At present, steel and aluminum drag chains have been widely used in stone machinery equipment, glass machinery, door and window machinery, manipulators, lifting and transportation equipment and other industries. The correct installation and use of steel and aluminum drag chains on stone machinery can prolong the service life of cables, oil pipes and air pipes, and reduce the production cost of enterprises. How to correctly install the steel-aluminum drag chain, the editor summarizes the three steps, I hope it can help everyone. Stone cutting machine Stone sawing machine Hand edge trimmer Grinding and polishing machine Stone machinery Stone engraving machine
First, the steel-aluminum drag chain should be placed symmetrically according to the weight and size of each cable. Place the heavier and larger cables on both sides, and the light and small cables in the middle. Stone cutting machine Stone sawing machine Hand edge trimmer Grinding and polishing machine Stone machinery Stone engraving machine
Second, if several cables with a diameter difference greater than 30 are to be placed in a drag chain during installation, they should be separated by partitions as much as possible. Case.
Third, the power cable used on the stone machine tool must have a margin of not less than 10%, and the water pipe must have a margin of not less than 20%. Avoid putting cables of different materials in the same energy chain, and pay attention to reducing wear during installation.
