The process of the ring sawing method of the diamond wire saw is: perforation-lasso-sawing.
Perforation: Perforate first at the design position of the sawing working surface. If it is vertical sawing, it needs to penetrate a vertical, a horizontal right angle to each other and intersecting holes. The aperture is 40-70mm. The vertical hole can be drilled by a drill, and the horizontal hole should be a horizontal guide trough type rock drill, which can penetrate a hole slightly higher than the ground, and can use the standard rod on the equipment to ensure accurate penetration with the vertical hole.
Lasso: After the two rope holes are penetrated, insert the beaded diamond rope into the vertical hole, take out the metal hook from the horizontal hole, butt the beaded diamond rope into an endless loop, and set it on the drive of the diamond sawing machine On the wheel. Open the diamond rope so that the two guide wheels and the two through holes should be on the same plane, in the correct direction, and not skewed. Sawing: Follow the operating requirements and steps to perform the sawing operation.
